Mopar 4578152AC Bracket-Engine Mount

You can Select Your Vehicle to check if 4578152AC fits your vehicle.

After raising the vehicle and securing it on jackstands, remove the front wheels and tires.

There are three powertrain mounts in this system. There are left and right engine mounts attached to the engine block and the subframe, and a rear mount attached to the transmission and the frame.

For replacement, follow these steps: Disconnect the cable from the negative terminal of the battery. Raise the vehicle and support it securely on jackstands (if not already done). Position a jack under the engine oil pan with a large wood block between the jack head and the oil pan. If you're removing the right side engine mount, remove the alternator support bracket. Remove the engine mount-to-subframe nuts and raise the engine with the jack. Remove the mount-to-engine bracket bolts. Install the new mount, making sure it is correctly positioned in the bracket. Install the fasteners and tighten them securely.

If movement is noted, lower the engine and tighten the mount fasteners. Rubber preservative should be applied to the mounts to slow down deterioration.

Remove the bolts holding the engine mount to the frame.

For replacement, follow these steps: Disconnect the cable from the negative terminal of the battery. Raise the vehicle and support it securely on jackstands (if not already done). Position a jack under the engine oil pan with a large wood block between the jack head and the oil pan. If you're removing the right side engine mount, remove the alternator support bracket. Remove the engine mount-to-subframe nuts and raise the engine with the jack. Remove the mount-to-engine bracket bolts. Install the new mount, making sure it is correctly positioned in the bracket. Install the fasteners and tighten them securely.