Mopar 55366767AD Bracket-Engine Mount

You can Select Your Vehicle to check if 55366767AD fits your vehicle.

Start by disconnecting the battery cable and raising the vehicle on jackstands. Support the engine and remove the through-bolts to detach the mount from the frame bracket and engine for 2WD models. For 4WD models, remove the skid plate, engine crossmember, and engine oil filter. Use an engine hoist to raise the engine slightly and take the weight off the mounts. Support the front axle with a floor jack and remove the engine mount through-bolts, as well as the bolts attaching the mounts to the front axle assembly and engine block. Lower the front axle slightly and remove the old mount. Install the new mount, ensuring correct positioning, and tighten the fasteners securely.

If any movement is observed between the inner and outer portions of the mounts, lower the engine and tighten the mount fasteners.

The engine mounting system consists of three molded mounts - two front mounts that support the engine assembly and one rear mount that supports the transmission and restricts torqueing action of the powertrain.

First, disconnect the battery cable, remove the engine cooling fan and shroud, and raise the front of the vehicle on jackstands. Support the engine from above using a lifting device, ensuring not to connect it to the intake manifold, and raise the engine to relieve mount weight. Depending on the model (2WD or 4WD), follow the respective steps to remove the engine mount, heat shield (if equipped), and support brackets. Then, install the new mount and heat shield. Lower the engine to guide the mount and through-bolt into the frame support bracket, secure the through-bolt nut, and complete the installation by reversing the removal steps. Finally, remove the engine hoist and jackstands, and lower the vehicle.

To check the engine mounts, the engine must be raised slightly to remove the weight from the mounts. The vehicle should be raised and securely supported on jackstands. Then, a jack should be placed under the engine oil pan with a large wood block between the jack head and the oil pan to prevent damage. The engine should be raised just enough to take the weight off the mounts. The mounts should be inspected for cracked, hardened, or separated rubber, as well as any relative movement between the mount plates and the engine or frame.

They should be replaced immediately to prevent damage or wear to the driveline components.