Mopar 4893194AA Head-Cylinder

You can Select Your Vehicle to check if 4893194AA fits your vehicle.

The initial steps are to relieve the fuel system pressure and disconnect the battery. Drain the cooling system and remove the drivebelt. Take out the PCV and EVAP system components, as well as the cowl.

After that, raise and securely support the front of the vehicle and unbolt the exhaust pipes from the exhaust manifolds.

Before removing the cylinder head, you should disconnect all wires and vacuum hoses from the cylinder heads. Also, disconnect the ignition coils and spark plugs. Remove the catalytic converter(s), valve covers, crankshaft pulley, and oil pans.

Remove the banjo bolt, sealing washers, and the fuel line from the rear of the head, then remove the fuel injectors. Remove the rocker housing and gasket. Loosen the head bolts in the reverse order of the tightening sequence, inserting each removed bolt into a cardboard template to keep track. Carefully pry between the head and block to break the gasket seal, then lift off the cylinder head, either with an assistant or using an engine lifting hoist. Inspect the head and remove any wiring harnesses or ground cables still attached.