Mopar 68044127AA INSULATOR-Engine Mount

You can Select Your Vehicle to check if 68044127AA fits your vehicle.

No, engine mounts seldom require attention.

To perform the inspection, raise the vehicle and support it securely on jackstands. Then, position a jack under the engine oil pan with a wood block between the jack head and the oil pan to raise the engine slightly. Check for relative movement between the inner and outer portions of the mounts.

Start by disconnecting the battery cable and raising the vehicle on jackstands. Support the engine and remove the through-bolts to detach the mount from the frame bracket and engine for 2WD models. For 4WD models, remove the skid plate, engine crossmember, and engine oil filter. Use an engine hoist to raise the engine slightly and take the weight off the mounts. Support the front axle with a floor jack and remove the engine mount through-bolts, as well as the bolts attaching the mounts to the front axle assembly and engine block. Lower the front axle slightly and remove the old mount. Install the new mount, ensuring correct positioning, and tighten the fasteners securely.

The engine mounting system consists of three molded mounts - two front mounts that support the engine assembly and one rear mount that supports the transmission and restricts torqueing action of the powertrain.

By raising the vehicle and supporting it securely on jackstands. Then, positioning a jack under the engine oil pan and raising the engine slightly to remove the weight from the mounts.

If any movement is observed between the inner and outer portions of the mounts, lower the engine and tighten the mount fasteners.