Mopar 5085393AC Line-Brake

You can Select Your Vehicle to check if 5085393AC fits your vehicle.

Clean the hose fittings, then disconnect the metal brake line from the hose fitting using a flare-nut wrench, being cautious not to damage the frame bracket or line. If the fitting is corroded, apply penetrating oil and allow it to soak before retrying. Remove the brake hose from the bracket, and if it's a rear brake hose on a drum-brake model, use a flare-nut wrench to loosen the line fitting at the wheel cylinder and remove the hose. For hoses attached to the caliper with a banjo bolt, unscrew the bolt and remove the hose, replacing the sealing washers on both sides of the fitting. Attach the new brake hose to the caliper or wheel cylinder, ensuring to use new sealing washers and tightening the banjo bolt to the specified torque. Insert the other end of the new hose through the bracket or attach the fitting/bracket to the vehicle, ensuring the hose isn't kinked or twisted, then fit the metal line to the hose (or hose fitting) and tighten the hose bracket and brake tube fitting nut securely. Check to ensure the hose doesn't make contact with suspension or steering components during vehicle operation.