Mopar 5080888AB Brake Mastr Cylinder

You can Select Your Vehicle to check if 5080888AB fits your vehicle.

If installing a new master cylinder, transfer the reservoir and install new seals. For installation, bench bleed the new master cylinder by clamping it in a vise and attaching bleeder tubes to the outlet ports. Fill the reservoir with the recommended brake fluid type and push the pistons into the master cylinder to expel air into the reservoir. Repeat until no air bubbles are present. Remove the bleed tubes, install plugs in the ports, and attach the reservoir cap. Install the master cylinder over the power brake booster studs, tighten the attaching nuts finger-tight, and thread the brake line fittings into the master cylinder. Fully tighten the nuts. Connect the brake fluid switch electrical connector, fill the reservoir with fluid, and bleed the master cylinder and brake system. Test the brake system's operation carefully before normal vehicle use.

Locate it in the engine compartment, mounted to the power brake booster. Remove excess fluid from the reservoir using a syringe or turkey baster. Place rags under the fluid fittings and prepare caps or plastic bags to cover the line ends once disconnected. Loosen the brake line fittings at the master cylinder using a flare-nut wrench to prevent damage.