Mopar 68258754AA Level Unit Module Kit

You can Select Your Vehicle to check if 68258754AA fits your vehicle.

Begin by removing the module. Detach the fuel level sensor from the fuel filter module by spreading the four locking tangs and pulling off the sensor. Cut the two wire ties that secure the wiring to the fuel return lines and disconnect the ground wires from the fuel filter module. Remove the fuel level sensor. If you're only replacing the fuel pressure regulator, you can stop here. To remove the fuel pressure regulator from the fuel filter module, pry off the retaining clip. Inspect the condition of the fuel pressure regulator O-rings. If you're replacing the fuel filter module, remove the ground ring from the recess for the fuel pressure regulator. When installing the ground ring in the new fuel filter module, ensure that the ground ring terminal is seated correctly in the notch. After installation, turn the ignition switch to On to activate the fuel pump and check for fuel leakage.

The installation is the reverse of removal, and after installation, the fuel system is primed by turning the ignition switch to On without operating the starter.