Mopar 53031102AB Rail-Fuel

You can Select Your Vehicle to check if 53031102AB fits your vehicle.

To remove the fuel tank filler neck cap and relieve pressure inside the fuel tank, as well as relieve fuel system pressure. Disconnect the cable from the negative terminal of the battery. Remove the air intake duct and air box resonator. Disconnect the fuel supply line from the fuel rail. Label and disconnect any vacuum hoses interfering with fuel rail removal. Disconnect electrical connectors from information sensors on the throttle body and set aside wiring harnesses. Disconnect fuel injector electrical connectors and set aside injector wiring harness. Remove ignition coils from the engine. Clean debris around the injectors and remove fuel rail mounting nuts/bolts. Gently rock the fuel rail and injectors to loosen and remove as an assembly. Do not separate left and right fuel rails. Remove injectors from fuel rail and discard O-rings. Coat new O-rings with clean engine oil and install on injectors. Insert injectors into corresponding bore in fuel rail and install retaining clip. Clean injector bores on intake manifold. Guide injectors/fuel rail assembly into injector bores on intake manifold and tighten mounting nuts/bolts. Reverse removal steps for installation. After installation, activate fuel pump without starting engine to build up fuel pressure and check for leaks. For HEMI engine, use special fuel line disconnection tool to disconnect metal collar fitting connecting fuel supply line to fuel rail.

To remove the fuel injectors, start by relieving the fuel pressure and disconnecting the battery cable. Remove the air intake duct/resonator from the air filter housing and throttle body. Use a special tool to remove the fuel line from the fuel rail and label and remove any interfering vacuum hoses or electrical wiring and connectors. On 2.4L four-cylinder engines, drain the coolant, remove the thermostat, injector wiring, PCV valve, and intake manifold bolts. On V6 engines, disconnect electrical connectors from the throttle body, remove ignition coils, and intake manifold (4.0L engines). Clean around the injectors and remove the fuel rail mounting nuts/bolts, then gently rock the fuel rail to remove it along with the injectors as an assembly. On V6 models, do not separate the left and right fuel rails, as both sides are serviced together. Remove the injectors from the fuel rail, discard the O-rings, and replace them with new ones coated in clean engine oil. Clean the injector bores on the intake manifold and insert the injectors into their corresponding bores in the fuel rail. Securely tighten the fuel rail mounting nuts/bolts, connect the fuel line(s), and ensure they are properly seated. Connect the electrical connectors to each injector, following numbered tags if present. Complete the installation process in reverse. After installation, turn the ignition switch to On a few times without starting the engine to build up fuel pressure and check for fuel leaks in the lines, fuel rail, and injectors.

To change the fuel injectors, remove the upper intake manifold. Unplug any vacuum hoses and electrical connectors that inhibit fuel rail removal. Take out the ignition coils and clean any debris around the injectors. Detach the fuel rail and injectors as a unit. Disconnect the supply line and the electrical connectors from the injectors. Detach the fuel rail and injectors together.

The old O-rings should be discarded, and new O-rings should be used for replacement.

Start by relieving the fuel system pressure and disconnecting the negative battery terminal.

Start by relieving the fuel pressure and disconnecting the battery cable. Remove the air intake duct/resonator from the air filter housing and throttle body. Use a special tool to remove the fuel line from the fuel rail and label and remove any interfering vacuum hoses or electrical wiring and connectors. On 2.4L four-cylinder engines, drain the coolant, remove the thermostat, injector wiring, PCV valve, and intake manifold bolts. On V6 engines, disconnect electrical connectors from the throttle body, remove ignition coils, and intake manifold (4.0L engines). Clean around the injectors and remove the fuel rail mounting nuts/bolts, then gently rock the fuel rail to remove it along with the injectors as an assembly.