Mopar 5080346AA Sensor-CAMSHAFT

You can Select Your Vehicle to check if 5080346AA fits your vehicle.

After removing the CMP sensor, remove the screw that attaches the target magnet to the camshaft and then take out the target magnet.

Inspect the CMP sensor O-ring for any damage and replace if necessary. Apply a small amount of clean engine oil to the sensor O-ring and use a rocking motion to install it into the sensor mounting bore. Ensure that the CMP sensor mounting flange is fully seated against the mounting surface. Inspect the old CMP sensor O-ring for damage and replace if needed. Apply engine oil to the O-ring and install it using a rocking motion. Make sure the CMP sensor mounting flange is fully seated. Check the O-ring for damage and apply engine oil before reinstalling the sensor. The remaining installation steps are the reverse of removal.