Mopar 56028994AB Oxygen Sensor

You can Select Your Vehicle to check if 56028994AB fits your vehicle.

The oxygen sensor in a vehicle's exhaust system reacts with the oxygen to produce a voltage output that indicates the amount of leftover oxygen in the exhaust. This feedback signal is continuously monitored by the PCM to determine the required fuel injection and control the air/fuel ratio. The ideal ratio for minimum emissions and fuel economy is 14.7 parts air to 1 part fuel. The post-converter oxygen sensor is used to monitor the efficiency of the catalytic converter. The configuration of the oxygen sensors varies depending on the vehicle's emissions package. The sensor operates correctly when it has good electrical connections, sufficient air supply, reaches the correct operating temperature, and uses unleaded fuel. The PCM can detect sensor problems and set Diagnostic Trouble Codes. To replace the oxygen sensor, raise the vehicle, locate the sensor and disconnect the electrical lead. Remove the sensor using a wrench or oxygen sensor socket. Clean the threads and apply anti-seize compound if reusing the old sensor. Installation is the reverse of removal.

The oxygen sensor in the exhaust system reacts with oxygen to produce a voltage output that varies depending on the oxygen content. This feedback signal is used by the PCM to determine the required fuel injector pulse width and control the air/fuel ratio. The ideal ratio is 14.7:1 for minimum emissions and optimal fuel economy and performance. The post-converter oxygen sensor monitors the efficiency of the catalytic converter. The sensor configuration varies depending on the engine model. The PCM operates in an open-loop fuel control mode until the sensor reaches its operating temperature. Proper operation of the sensor depends on electrical connections, air supply, operating temperature, and the use of unleaded fuel. The PCM can detect sensor problems and set diagnostic trouble codes. When replacing the sensor, precautions should be taken to avoid damage or contamination. The sensor should be installed using anti-seize compound on the threads.

Oxygen sensors in a vehicle play a crucial role in monitoring the air/fuel ratio and the efficiency of the catalytic converter.

The post-converter oxygen sensor, although not used for air/fuel ratio control, is used by the PCM to monitor the efficiency of the catalytic converter.

Oxygen sensors in a vehicle play a crucial role in monitoring the air/fuel ratio and the efficiency of the catalytic converter.

The oxygen sensor in a vehicle's exhaust system reacts with the oxygen to produce a voltage output that indicates the amount of leftover oxygen in the exhaust. This feedback signal is continuously monitored by the PCM to determine the required fuel injection and control the air/fuel ratio.

The configuration of the oxygen sensor varies depending on the model and emissions package.

No, the emission maintenance timer cannot be reset. It must be replaced or disconnected to turn out the indicator light.