Mopar 68140296AA Rear Axle Shaft

You can Select Your Vehicle to check if 68140296AA fits your vehicle.

To check the axleshaft bearing, raise the vehicle, remove the wheel and brake drum, and move the axle flange to check for wear. Look for differential lubricant leakage indicating a seal issue. To remove the axleshaft, drain the differential carrier, remove the lock bolt and shaft, and remove the C-lock. Carefully withdraw the axleshaft, avoiding oil seal damage. Reinstall in reverse order, using a new gasket and correct torque. Refill with correct lubricant. For a full-floating axleshaft, loosen lug nuts, raise the vehicle, remove the wheel and flange bolts, and pull out the axleshaft. Clean the flange, inspect and replace seals and bearings if needed. Install a new gasket, apply RTV sealant, and push the axleshaft into the housing. Install flange bolts and wheel, then lower the vehicle and tighten lug nuts.

Support the axle assembly with a floor jack under the differential.

The driveshaft needs to be disconnected from the rear axle.

The light-duty axles have a semi-floating design.

The first step is to loosen the wheel lug nuts.

If the U-joint is worn, it can be replaced.