Mopar 4656528AC Front Suspension Coil Spring

You can Select Your Vehicle to check if 4656528AC fits your vehicle.

Mount the strut clevis bracket portion of the strut assembly in a vise, being careful not to clamp any other portion of the strut assembly. Install the spring compressor on the spring and compress it sufficiently to relieve all pressure from the upper spring seat. While holding the damper shaft from turning, loosen the shaft nut with a socket. Remove the nut and suspension support, inspecting the bearing and rubber portion for any issues. Remove the upper spring seat and dust boot from the damper shaft, as well as the rubber bumper. Carefully lift the compressed spring from the assembly and set it in a safe place, making sure to mark it for reinstallation.

Installation is the reverse of the removal procedure, but make sure the coil springs are positioned properly against their upper mounts. Before tightening any of the suspension fasteners to the torque values, raise the rear axle to normal ride height with the floor jack(s). Install the wheel and lug nuts. Lower the vehicle and tighten the lug nuts to the torque.