Mopar 5272884AA Rear Coil Spring

You can Select Your Vehicle to check if 5272884AA fits your vehicle.

Extend the damper rod and install the rubber bumper. Position the coil spring with the smaller coils going on first and carefully place it onto the damper shaft. Install the rubber bumper and push it all the way down. Install the upper spring seat and dust boot onto the damper shaft. Install the suspension support, aligning the support notch with the clevis bracket on the strut support. Install the nut and tighten it to the specified torque. Loosen the coil spring compressor(s) until the top coil is properly seated against the upper spring seat and suspension support. Relieve all tension from the spring compressor(s) and remove them from the coil spring. Finally, install the strut/spring assembly.

Support the center of the rear axle with a floor jack. Raise the jack(s) slightly to take the spring pressure off the shock absorber lower mounts. Remove the shock absorber lower mounting bolts.