Mopar 68042808AC Rear Coil Spring

You can Select Your Vehicle to check if 68042808AC fits your vehicle.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.

During the installation of the coil spring, start by placing the insulator on top of the coil spring. Install the top of the spring into the spring pocket and the bottom of the spring into the lower control arm. After this, reconnect the lower control arm to the steering knuckle. Following the successful installation of the coil spring, you can remove the spring compressor. The rest of the installation process should follow the reverse of the removal steps. Make sure to tighten all fasteners to their proper torque values and also tighten the wheel lug nuts. Lastly, it's advisable to have the front end alignment checked and adjusted if necessary.

After raising the vehicle and securely supporting it on jackstands, remove the wheels. Then, use floor jacks to support the end of the axle from which you're removing the spring. Install a coil spring compressor on the coil spring and slightly compress the spring. Following this, remove the upper suspension arm and loosen the lower suspension arm nuts and pivot bolts. Additionally, mark and disconnect the front driveshaft from the front axle. Disconnect the track bar from the frame rail bracket, the drag link from the Pitman arm, and the stabilizer bar link from the axle. Finally, disconnect the shock absorber from the axle and lower the axle until the coil spring is free for removal.

Reverse the removal process and tighten all fasteners.