Mopar 68042809AC Rear Coil Spring

You can Select Your Vehicle to check if 68042809AC fits your vehicle.

As part of the removal process, you should remove the shock absorber. Additionally, it's important to install a suitable internal-type spring compressor. Compress the coil spring sufficiently using the compressor to relieve all pressure from the upper spring seat.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.

Reverse the removal process and tighten all fasteners.

During the installation of the coil spring, start by placing the insulator on top of the coil spring. Install the top of the spring into the spring pocket and the bottom of the spring into the lower control arm. After this, reconnect the lower control arm to the steering knuckle. Following the successful installation of the coil spring, you can remove the spring compressor. The rest of the installation process should follow the reverse of the removal steps. Make sure to tighten all fasteners to their proper torque values and also tighten the wheel lug nuts. Lastly, it's advisable to have the front end alignment checked and adjusted if necessary.