Mopar 4801269AD Starter Motor

You can Select Your Vehicle to check if 4801269AD fits your vehicle.

Detach the cable from the negative terminal of the battery. Raise the vehicle and support it securely on jackstands. On models equipped with 4WD, detach the left side exhaust down-pipe from the crossover pipe and lower the crossover pipe to allow clearance for removal of the front driveshaft. If equipped, remove the front driveshaft. Remove the heat shield from the starter motor. Disconnect the battery cable and wires from the terminals on the starter motor solenoid. Disconnect any clips securing the wiring to the starter. Remove the two starter mounting bolts and remove the starter from the engine. Note: On 3.7L V6 engines, position the starter so that the front of the starter faces the rear of the vehicle and the solenoid faces downward, then remove the starter by passing it between the exhaust pipe and transmission bellhousing. Installation is the reverse of removal.

Check the battery cable clamps for cleanliness and tightness, inspect the battery cables, and test the battery's condition. Verify the starter motor wiring, mounting bolts, related fuses, ignition switch circuit, starter relay, and the operation of the clutch safety switch or Park/Neutral position switch. If the starter doesn't activate when turning the ignition switch, check for battery voltage to the starter solenoid to ensure it's receiving the correct voltage.