Mopar 4764859AA STRUT-Suspension

You can Select Your Vehicle to check if 4764859AA fits your vehicle.

Start by removing it and reinstalling the clevis bracket on the shock absorber. Clamp the shock absorber in a vertical position in a vise. Next, compress the coil spring using a coil spring compressor and remove the shock absorber damper rod nut. Take off the damper rod washer, upper control arm mounting bracket, and isolator bushings from the damper rod. Remove the shock absorber upper isolator bushing, lower isolator bushing, and sleeve from the upper control arm mounting bracket. Then, remove the upper spring isolator from the mounting bracket and the lower isolator bushing from the damper rod sleeve. Remove the washer and dust shield from the shock absorber assembly, followed by the compressed coil spring. Take off the jounce bumper and sleeve from the shock absorber assembly, as well as the coil spring isolator from the lower spring seat on the shock absorber.

Check for leaking fluid, dents, cracks, and other obvious damage. Also, check the coil spring for chips and corrosion. Replace any damaged components.

Guide the shock absorber into place, insert the upper mounting studs through the holes in the shock tower, and tighten the nuts. Connect the lower end of the shock absorber to the knuckle and tighten the bolt/nut. Install the wheels, lower the vehicle, and tighten the lug nuts. Finally, tighten the upper mounting nuts and install the cap.