Mopar 4728424 Switch-Multifunction

You can Select Your Vehicle to check if 4728424 fits your vehicle.

Disconnect the negative battery cable, then remove the instrument cluster bezel. Next, take out the mounting plate screws associated with the headlight switch. Pull the switch assembly out of the dash and unplug the electrical connector. Press the release button on the side of the switch to withdraw the switch knob and shaft. Remove the screws to detach the switch from the mounting plate and take out the switch. Snap the escutcheon out of the dash and remove the nut holding the switch on the mounting plate. Installation is the reverse of removal.

To verify the operation of the dimmer switch the following steps need to be followed; first is to disconnect the steering column by removing the cover and also pull the electrical connector of the switch. Continuity can be tested using an ohmmeter between the switch terminals; between the B and H terminals should show continuity in the high beam position and between the B and L terminal in the low beam position. Otherwise they need to be replace This might be due to the absence of continuity existed and hence the switch has to be replaced. For replacement, unbolt the two bolts to bring the switch down from the steering column, then put the new switch in its proper position, and screw in the bolts to fit hand tight. Make an adjustment pin out of a piece of wire/ Disengage this switch to the rear so that there is no unnecessary play on the actuator control rod/ Then it is time to tighten the bolts. Finally and last, take the pin; connect the connector as it is shown above; and replace the steering column cover.

To remove the cluster face plate, first remove the left air-conditioning duct if necessary. Then, reach under the instrument panel and depress the stem and knob release button on the bottom of the switch housing. Pull the knob and stem assembly out of the switch housing. For later model vehicles, remove the wiper switch knob and bezel. Remove the switch spanner nut from the front of the instrument panel. Reach under the instrument panel and maneuver the switch down to disconnect the electrical leads. Finally, remove the switch. The installation process is the reverse of removal.

These models feature a multi-function lever on the left side of the steering column that manages the wiper/washer, turn signal, and dimmer switches.

Remove the screws to detach the switch from the mounting plate and take out the switch.

If continuity is not present, the switch needs to be replaced.

The wipers operate at two speeds with an intermittent function, controlled by a module located under the instrument panel or in the body computer.