Mopar 53034192AA Valve-EGR

You can Select Your Vehicle to check if 53034192AA fits your vehicle.

The EGR valve is located on the front of the right cylinder head.

To clean the EGR cooler on 6.4L HEMI and diesel models, you need to disconnect the battery cables and drain the cooling system. Remove various components like the air filter housing, turbo outlet tube, alternator, and more to access the cooler. Remove the EGR cooler and discard the gasket. Clean it with hot tap water and a cleaning solution. Rinse, dry, and reinstall with a new gasket.

For V6 engines, the installation process is the reverse of removal. When replacing the EGR valve, always use a new gasket. If replacing the EGR pipe, replace the gasket at the EGR valve end, and for 3.7L V6 engines, replace the seal at the intake manifold end. For 4.0L V6 engines, use a new gasket at the flange.

Disconnect the cable from the negative terminal of the battery and drain the cooling system. Remove the engine cover, disconnect the electrical connector and cooler hose from the EGR valve. Remove the mounting nuts and detach the EGR valve from the cylinder head. Clean the mating surfaces and install a new gasket. Position the EGR valve against the cylinder head and tighten the nuts. Connect the cooler hose and install the clamp. Reconnect the electrical connector and install the engine cover. Reconnect the cable to the negative terminal of the battery and refill the cooling system.