Mopar 53034194AA Valve-EGR

You can Select Your Vehicle to check if 53034194AA fits your vehicle.

For installation, tighten the EGR tube mounting flange bolts to the specified torque.

To reset the "Emissions System Service Required" light, you need to follow a specific procedure involving the accelerator pedal and key positions without starting the engine.

Disconnect the cable from the negative terminal of the battery and drain the cooling system. Remove the engine cover, disconnect the electrical connector and cooler hose from the EGR valve. Remove the mounting nuts and detach the EGR valve from the cylinder head. Clean the mating surfaces and install a new gasket. Position the EGR valve against the cylinder head and tighten the nuts. Connect the cooler hose and install the clamp. Reconnect the electrical connector and install the engine cover. Reconnect the cable to the negative terminal of the battery and refill the cooling system.

For diesel engines, remove the cover from the EGR crossover tube, loosen clamps, remove bolts, disconnect wiring, pry off the valve assembly, clean sealing surfaces, and replace gaskets. Diesel models may also have an EGR cooler located under the intake manifold or on the exhaust manifold.