Mopar 68211310AA Valve-EGR

You can Select Your Vehicle to check if 68211310AA fits your vehicle.

For the first 60,000-mile interval in specific states, Dodge dealers perform EGR valve cleaning at no cost. To clean the EGR valve on diesel models, remove it along with the EGR valve motor and shim, then disassemble the valve components, including the keeper retainer, keepers, and valve spring. Clean the valve housing surfaces and other areas with a plastic scrub brush and soak the assembly in a solution of Mopar EGR system cleaner and water. Rinse, dry, and reassemble the valve components before installation. For EGR cooler cleaning on 6.4L HEMI and diesel models, disconnect battery cables, drain the cooling system, and remove various components like the air filter housing, turbo outlet tube, alternator, and more to access the cooler. Remove the EGR cooler and discard the gasket, then clean it with hot tap water and a cleaning solution. Rinse, dry, and reinstall with a new gasket. Finally, reset the "Emissions System Service Required" light by following a specific procedure involving the accelerator pedal and key positions without starting the engine.

Remove the air intake duct and air filter housing. Remove the EGR tube mounting flange bolts and the wire retaining clip that secures the other end of the EGR pipe to the throttle body. Installation is the reverse of removal, ensuring the EGR tube mounting flange bolts are tightened properly.

When emitted from the tailpipe, NOx combines with other compounds and sunlight to create ozone and smog.