×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Dodge Avenger Oil Cooler
Engine Oil Cooler- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
7 Oil Coolers found
Dodge Avenger Oil Cooler
Need of Oil Cooler in Dodge Avenger vehicles can be summarized in few following points: Regulation of temperature of engine oil is important so that the viscosity characteristic of the engine oil can be maintained. Through the use of oil- to- water cooling system, the Oil Cooler is in line with the cooling system in the vehicle enabling the oil to warm up efficiently and avoiding extreme heat, which adversely affects the carrying capacity of the oil. Different types of Oil Coolers have been used in Dodge Avenger over the years with a major concern towards cooling during high loads. As for the factory-installed coolers, they normally may be insufficient to provide protection during extreme conditions, like towing in hot climate. In such situations, increasing the cooling ability of the system can be accomplished using oil cooler kits available from parts producers, problems included by clogging, or corrosion to the original oil cooler could be encountered. In general, the Oil Cooler is crucial for the proper functioning of vehicles of the Dodge Avenger brand, protecting the engine from possible breakdowns.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Dodge Avenger Oil Cooler at great affordable prices. Moreover, all genuine Dodge Avenger Oil Cooler come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Dodge Avenger Oil Cooler Parts Questions & Experts Answers
- Q: What are the steps involved in the removal and installation process of the oil cooler on Dodge Avenger?A: In performing this change, first clear the fuel pressure and afterward, further, disconnect the negative terminal on the battery or the remote ground terminal. Next, drain the coolant. Then, take out the lower intake manifold, and the oil cooler mounting screws, and bolts. Go ahead and pull out the oil cooler and throw away the seals. In performing installation, first of all, new seals has to be installed into an oil cooler. Next, fit the oil cooler onto the block and then install the two screws that are used for the mounting, then the two bolts, before you tighten the bolts to the recommended torque. As for the rest of the installation the order is the inversion of the removal order. Last, add more water to the cooling system, start the car and let the engine to reach normal temperature and look for signs of leakage.
