Chrysler 68164722AC ABSORBER-Suspension

You can Select Your Vehicle to check if 68164722AC fits your vehicle.

In the trunk, the two nuts that hold the shock absorber to the vehicle body should be removed.

The final step is to install the NEW strut retaining clip.

To disassemble the strut and spring assembly, you need to mount the strut clevis bracket portion in a vise and mark the components for reassembly. Then, install a spring compressor on the spring and compress it to relieve pressure from the upper mount. While holding the damper shaft, loosen the shaft nut with a socket. Remove the nut and upper mount, inspecting the pivot bearing and upper spring seat for damage. Lift the compressed spring from the assembly and remove the dust boot from the damper shaft. Slide the rubber bumper off the damper shaft and check the lower spring isolator for damage.

Some signs of wear include leaking fluid, loss of damping capability, and chipped, sagging, or cracked coil springs.

In the trunk, the two nuts that hold the shock absorber to the vehicle body should be removed.

The strut assembly should be guided up into the fenderwell by inserting the upper mounting studs through the holes in the body.

Compress the coil spring with a spring compressor, following the tool manufacturer's instructions. Compress the spring until tension is removed from the upper bracket.

Compress the coil spring with a spring compressor, following the tool manufacturer's instructions. Compress the spring until tension is removed from the upper bracket.