Chrysler 68253167AB ABSORBER-Suspension

You can Select Your Vehicle to check if 68253167AB fits your vehicle.

After simulating normal ride height, the lower mounting bolt should be tightened, the wheel and lug nuts should be installed, and the vehicle should be lowered and the lug nuts tightened. On 2014 and earlier models, the shock absorber upper mounting nuts should also be tightened. Finally, the trim panels in the trunk should be reinstalled.

The strut body, coil spring, and spring seat should be inspected for damage.

To reassemble the strut and spring assembly, you need to extend the damper rod and install the rubber bumper. Put the dust boot onto the damper and carefully place the coil spring onto the damper, aligning it with the reference marks made during disassembly. Install the upper spring isolator and seat, followed by the upper mount, and tighten the nut on the damper shaft. Loosen the coil spring compressor until the top coil is properly seated against the upper spring seat and upper mount. Finally, remove the tool from the coil spring and install the strut/spring assembly.

Slowly release tension from the spring by backing off the spring compressor. Ensure the spring has settled in the locator holes and the brackets/mounts are not twisted or off-center.