Chrysler 5085517AE Bracket-Engine Mount

You can Select Your Vehicle to check if 5085517AE fits your vehicle.

To replace the right mount, raise the vehicle, remove the power steering fluid reservoir, support the engine, and take out the engine mount bracket and the mount itself. Replace it with a new one and tighten the bolts.

For the rear mount: 1. Raise the vehicle and remove the engine splash shield and downstream oxygen sensor. 2. Support the engine. 3. Remove the rear mount bracket-to-subframe bolts and the mount through-bolt. 4. Remove the mount by twisting it slightly. 5. Install the new mount into the bracket and tighten the through-bolt by hand. 6. Align the mount to the subframe, install and tighten the bolts to the specified torque, and finish by tightening the through bolt. 7. Installation follows the reverse order.

For the front mount replacement: 1. Raise the vehicle and remove the splash shield. 2. Support the engine with a block of wood. 3. Remove the front mount through-bolt and crossmember-to-mount bolts. 4. Take out the mount. 5. If the mount bracket needs replacement, remove the bracket-to-block bolts. 6. Installation follows the reverse order.

For the rear mount replacement, remove the throttle body air inlet tube and air filter housing, raise the vehicle, and remove the rear mount bracket-to-transaxle bolts. Separate the bracket from the mount, remove the mount-to-subframe mounting bolts, and replace the mount with a new one. Install the bracket and through-bolt to the mount, then install the mount to the subframe and transaxle, tightening all bolts to the specified torque.

To replace the front mount, the vehicle must be raised and supported securely, the weight from the mounts must be relieved, and the necessary bolts must be removed to install a new mount.

For the rear mount replacement, remove the throttle body air inlet tube and air filter housing, raise the vehicle, and remove the rear mount bracket-to-transaxle bolts. Separate the bracket from the mount, remove the mount-to-subframe mounting bolts, and replace the mount with a new one. Install the bracket and through-bolt to the mount, then install the mount to the subframe and transaxle, tightening all bolts to the specified torque.

To check the mounts, the engine must be raised slightly to remove the weight from them. This involves securely supporting the vehicle on jackstands, positioning a jack under the engine oil pan with a wood block to prevent damage, and carefully raising the engine.

To check the mounts, the engine must be raised slightly to relieve weight from them. Begin by raising the vehicle and securely supporting it on jackstands, then remove the front wheels and tires. Position two jacks, one under the crankshaft pulley and the other under the transaxle bellhousing, using a block of wood to protect the components while raising the engine/transaxle just enough to relieve the mounts. Inspect the mounts for any cracks, hardening, or separation from the metal plates, and check for movement between the mount plates and the engine or subframe, tightening any loose fasteners as necessary. Applying rubber preservative can help slow deterioration.