Chrysler 68042934AB Level Unit Module Kit

You can Select Your Vehicle to check if 68042934AB fits your vehicle.

This procedure is only applicable to 2014 and earlier models. For 2015 and later models, the fuel level sensor cannot be serviced and must be replaced as a complete assembly with the fuel pump module. To begin, remove the fuel pump/fuel pressure regulator/fuel level sensor assembly. Next, disconnect the electrical connector of the fuel level sensor by depressing the tab and disconnecting it from the underside of the fuel pump module. It is important to avoid touching the terminals or the sensor resistor card, as well as pulling the sensor by the wires or float arm. Then, press the fuel level sensor snap tab to the left while gently pushing up on the bottom of the sensor to remove it. Using a narrow electrical connector terminal tool, dislodge the sensor terminals from the connector body and install the terminals of the new sensor into the correct positions in the connector. Finally, the remaining steps for installation are the reverse of the removal process.

AWD models have a saddle fuel tank configuration.