Chrysler 4686360AB Throttle Position Sensor

You can Select Your Vehicle to check if 4686360AB fits your vehicle.

Disconnect the cable from the negative terminal of the battery. Remove the throttle body. Remove the two TP sensor mounting screws and remove the TP sensor. Remove and inspect the old TP sensor O-ring. If it's cracked, dried out, torn or otherwise deteriorated or damaged, replace it. When installing the TP sensor, make sure that the new O-ring is in place, then align the lugs on the backside of the sensor with the blade on the end of the throttle shaft. The blade MUST fit between these two lugs or the TP sensor will not operate correctly. Once the blade on the throttle shaft is centered between the TP sensor lugs, rotate the TP sensor as necessary to align the mounting holes in the sensor with the mounting holes in the throttle body. Installation is otherwise the reverse of removal.

To replace the Throttle Position Sensor (TPS), follow the steps for replacement, including removal of the air cleaner assembly for the 2.5L engine, unplugging the electrical connector, removing the screws retaining the TPS, and reinstalling it securely.

Remove the throttle body.

The Throttle Position Sensor (TPS) is monitored by the computer.

If a Code 24 is displayed, the first step is to check the circuit and, if necessary, replace the TPS.