Jeep 68313570AA Sensor-Knock

You can Select Your Vehicle to check if 68313570AA fits your vehicle.

For the coolant temperature sensor, open the radiator cap, squeeze the upper radiator hose, reinstall the cap, unplug the electrical connector, unscrew the sensor, coat the threads of the new sensor, install it securely, and check the coolant level.

To replace the knock sensors, start by disconnecting the cable from the negative battery terminal. Then, disconnect the knock sensor electrical connector, which is located at the rear of the engine, behind the intake manifold. If you can't find the connector, wait until you have removed the intake manifold and locate the two knock sensors and trace their leads back to the common connector. Remove the intake manifold and then remove the knock sensor assembly by removing the mounting bolts. Make sure to clean the holes for the mounting bolts before installing the new knock sensor assembly. For 3.7L V6 engines, note that the left knock sensor is identified by an identification tag and has a larger mounting bolt. Do not install the left knock sensor in the right sensor mounting position and vice versa, as it will confuse the PCM and cause a Diagnostic Trouble Code. Installation is the reverse of removal, making sure to tighten the knock sensor mounting bolts to the common connector. Remove the intake manifold and then remove the knock sensor assembly by removing the mounting bolts. Make sure to clean the holes for the mounting bolts before installing the new knock sensor assembly. For 3.7L V6 engines, note that the left knock sensor is identified by an identification tag and has a larger mounting bolt. Do not install the left knock sensor in the right sensor mounting position and vice versa, as it will confuse the PCM and cause a Diagnostic Trouble Code. Installation is the reverse of removal, making sure to tighten the knock sensor mounting bolts to the correct torque.