Mopar 4895727AA ABSORBER-Suspension

You can Select Your Vehicle to check if 4895727AA fits your vehicle.

Inspect the shock absorber for leaking fluid, dents, cracks and other damage. Inspect the coil spring for chips and cracks which could cause premature failure. Inspect the spring seats for hardness and general deterioration.

Remove the cap on the shock tower and remove the fasteners that attach the upper end of the shock to the frame. Loosen the front wheel lug nuts. Raise the front of the vehicle and support it securely on jackstands. Remove the front wheels. Disconnect the stabilizer bar link from the shock assembly. Remove the fasteners attaching the lower end of the shock absorber to the lower control arm. Pull down on the lower control arm and remove the shock absorber towards the rear of the vehicle.

When servicing the left shock absorber, remove the rubber hose between the fuel filler neck and the gas tank and move the filler neck aside. If dealing with dual exhaust or the right shock absorber, lower the exhaust and support it with jackstands or another jack. Place a floor jack under the rear differential to support the suspension and subframe. Support the spring link with a floor jack and wood block and remove the fasteners attaching the upper end of the shock absorber to the frame. Slowly lower the floor jack supporting the spring link. Remove the fasteners at the lower end of the shock and mark the subframe in relation to the chassis before removing the front and rear subframe fasteners on the side being worked on.

Clean the lower end of the steering knuckle and have an assistant move the wheel in and out while checking for movement at the steering knuckle-to-control arm balljoint. If there is any movement, the suspension balljoint(s) must be replaced.

Start by raising the rear of the vehicle and supporting it securely on jackstands. Remove the wheel and support the spring link with a floor jack. Remove the fasteners attaching the upper end of the shock absorber to the frame and then remove the fasteners at the lower end.

Clean the lower end of the steering knuckle and have an assistant move the wheel in and out while checking for movement at the steering knuckle-to-control arm balljoint. If there is any movement, the suspension balljoint(s) must be replaced.