Mopar 4782733AD Shock-Suspension

You can Select Your Vehicle to check if 4782733AD fits your vehicle.

Remove the cap on the shock tower and remove the fasteners that attach the upper end of the shock to the frame. Loosen the front wheel lug nuts. Raise the front of the vehicle and support it securely on jackstands. Remove the front wheels. Disconnect the stabilizer bar link from the shock assembly. Remove the fasteners attaching the lower end of the shock absorber to the lower control arm. Pull down on the lower control arm and remove the shock absorber towards the rear of the vehicle.

The steering linkage and suspension components should be checked periodically.

Start by raising the rear of the vehicle and supporting it securely on jackstands. Remove the wheel and support the spring link with a floor jack. Remove the fasteners attaching the upper end of the shock absorber to the frame and then remove the fasteners at the lower end.

Raise the vehicle and support it securely on jack stands to check the shock absorbers for evidence of fluid leakage. A light film of fluid is not a cause for concern, but if leakage is noted, the shocks should be replaced as a set. Also, check the shocks to ensure they are securely mounted and undamaged, and inspect the upper mounts for damage and wear.

When servicing the left shock absorber, remove the rubber hose between the fuel filler neck and the gas tank and move the filler neck aside. If dealing with dual exhaust or the right shock absorber, lower the exhaust and support it with jackstands or another jack. Place a floor jack under the rear differential to support the suspension and subframe. Support the spring link with a floor jack and wood block and remove the fasteners attaching the upper end of the shock absorber to the frame. Slowly lower the floor jack supporting the spring link. Remove the fasteners at the lower end of the shock and mark the subframe in relation to the chassis before removing the front and rear subframe fasteners on the side being worked on.

Installation is the reverse of removal. Tighten the mounting fasteners. Note: Raise the lower control arm with a floor jack to simulate normal ride height before lightening lower shock absorber mounting fasteners. Tighten the wheel lug nuts.

Start by raising the rear of the vehicle and supporting it securely on jackstands. Remove the wheel and support the spring link with a floor jack. Remove the fasteners attaching the upper end of the shock absorber to the frame and then remove the fasteners at the lower end.

To check the shock absorbers, park the vehicle on level ground, turn off the engine, and set the parking brake. Push down at one corner of the vehicle and release it, noting the movement of the body. It should stop moving and come to rest in a level position within one or two bounces. If the vehicle continues to move up and down or fails to return to its original position, a worn or weak shock absorber is likely the reason. Repeat this check at each of the three remaining corners of the vehicle.

Inspect the shock absorber for leaking fluid, dents, cracks and other damage. Inspect the coil spring for chips and cracks which could cause premature failure. Inspect the spring seats for hardness and general deterioration.

5180999AA IS FOR THE LEFT FRONT 5180998AA IS FOR THE RIGHT FRONT THESE ARE THE STRUTS THAT CAME WITH THE VEHICLE FROM THE FACTORY