Chrysler 68080774AC Bracket-Engine Mount

You can Select Your Vehicle to check if 68080774AC fits your vehicle.

For the right mount: 1. Remove the coolant reservoir and power steering line bracket fastener. 2. Raise the vehicle and support the engine. 3. Remove the engine mount bracket bolts and the engine mount bolts. 4. Replace the mount and tighten the mount-to-body bolts to the specified torque. 5. Lower the engine and tighten the mount-to-bracket bolts. 6. Installation follows the reverse order.

Replacing the left mount involves disconnecting the negative battery cable, removing the air filter and housing, and following similar steps to replace the mount.

To check the mounts, the engine must be raised slightly to relieve weight from them. Begin by raising the vehicle and securely supporting it on jackstands. Then, remove the front wheels and tires. Position two jacks-one under the crankshaft pulley and the other under the transaxle bellhousing-using a block of wood to protect the components while raising the engine/transaxle just enough to relieve the mounts. Inspect the mounts for any cracks, hardened rubber, or separation from the metal plates, and check for movement between the mount plates and the engine or subframe. Tighten any loose fasteners as necessary. Applying rubber preservative can help slow deterioration.

Replacing the left mount involves disconnecting the negative battery cable, removing the air filter and housing, and following similar steps to replace the mount.

For the rear mount: 1. Raise the vehicle and remove the engine splash shield and downstream oxygen sensor. 2. Support the engine. 3. Remove the rear mount bracket-to-subframe bolts and the mount through-bolt. 4. Remove the mount by twisting it slightly. 5. Install the new mount into the bracket and tighten the through-bolt by hand. 6. Align the mount to the subframe, install and tighten the bolts to the specified torque, and finish by tightening the through bolt. 7. Installation follows the reverse order.

For the rear mount, access the top rear of the engine compartment to remove the mounting bracket-to-block bolts. Then, raise the vehicle and take out the mount assembly. Replace it with a new one and secure it to the subframe and engine block with the appropriate torque.

There are four powertrain mounts: 1. The front mount connects the transaxle to the crossmember. 2. The left mount secures the driver's side of the engine to the subframe. 3. The right engine mount attaches the engine block to the passenger's side of the subframe. 4. The rear mount links the engine block to the subframe.

The four powertrain mounts are: 1. The front mount, which connects the transaxle to the crossmember. 2. The left mount, which secures the driver's side of the engine to the subframe. 3. The right engine mount, which attaches the engine block to the passenger's side of the subframe. 4. The rear mount, which links the engine block to the subframe.