×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Dodge Neon MAP Sensor
Manifold Air Pressure Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
5 MAP Sensors found
Dodge Neon MAP Sensor
In the Dodge Neon cars, the use of MAP Sensor as a crucial tool is apparent since its works by measuring the positive air pressure that gets to the intake manifold. This small device sends signals to the engine control unit (ECU), making it possible to control the fuel injectors depending on the amount of air present in the cylinders so as to ensure the right air -fuel mixture for combustion is achieved. The Dodge Neon cars that use the MAP Sensor are those that are naturally aspirated, and can be combined with the mass airflow (MAF) sensor. The MAP Sensor works on speed density principle which estimates air density in order to regulate fuel supply. Unlike boost sensors, it measures absolute pressure which makes it important for reading that are so vital for engine power, fuel consumption, and timing of ignition.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Dodge Neon MAP Sensor at great affordable prices. Moreover, all genuine Dodge Neon MAP Sensor come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Dodge Neon MAP Sensor Parts Questions & Experts Answers
- Q: How do you disconnect and replace the MAP sensor on Dodge Neon?A: Disconnect the negative battery cable. The MAP sensor is located on the front right corner of the intake manifold. Disconnect the electrical connector from the MAP sensor. Remove the retaining screws of the MAP sensor and then detach the sensor from the intake manifold, ensuring to discard the old O-rings and replace them. Whether installing the old MAP sensor or a new unit, new O-rings should be installed on the sensor. Installation is the reverse of removal, taking care not to damage the O-rings during the process.
